2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

torque specification

Reply Subscribe

Search this Thread

Old

Apr 21, 2007 | 05:44 PM

#1

macelano

Thread Starter

Joined: Apr 2007

Posts: 2

Likes: 0

Default

torque specification

I just replaced the drive shaft u-joints, andIneed the torque specification for the drive shaft to rear diff. bolts.I have a Dodge Ram 1500.

Any help would be appreciated.

Thank you

Reply

Old

Apr 21, 2007 | 05:55 PM

#2

DieselDemon

Record Breaker

Joined: Feb 2005

Posts: 1,325

Likes: 1

From:

Default

RE: torque specification

Maybe the year, engine, etc.

You're talking about the two straps that bolt down over the u-joint caps, correct?

Reply

Old

Apr 21, 2007 | 09:31 PM

#3

macelano

Thread Starter

Joined: Apr 2007

Posts: 2

Likes: 0

Default

RE: torque specification

There are actually no straps on the rear, unlike the front. The flange that attaches to the u-joint and then then to to drive shaft. It is a four bolt connection (15mm). The year is 2000 5.2 L, 4x4. Thanks

Reply

Old

Apr 23, 2007 | 10:37 PM

#4

TMS Bill

Record Breaker

Joined: Jul 2006

Posts: 2,400

Likes: 1

From: Warren, NJ

Default

RE: torque specification

The companion yoke to companion flange bolts are to be torqued to 80 ft-lbs.

Reply

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

All times are GMT -4. The time now is 05:01 PM.