Hey everyone,i just got my rebuilt motor together except the freakin valve covers. The reason why there not on yet is because i dont know where the bolts go some have studs and some dont i was wondering if anyone had a diagram or any pics of the bolts so i can finally finish my motor and get it in.Its a 97 1500 with a 360 in it.

Thanks,
Matt.

 

98 Ram 5.2 you mileage may vary. pass. side s___ s___b___s___s Front of truck >

s___b___s___b___s

the studs are only for the plastic clips for wire harness and sparkplug holders

 

driver side < front of truck b___s___b___s___s

b___s___s___b____s


Do not tighten them all the way until you run the plug wires and harness

 

they dont really matter because you are still going to close the valve covers, i perferably put the bolts in the back of the engine due to when you have the engine in they will be alittle hard to get

 

They don't all matter and some are not even used, but if he is using the factory harness' and plug wire clips they will want to be in the right position. But that is why I said don't tighten them yet.