It will take a few times of bending and tweaking it, but once you get it right, it goes on and off very easily.

 

I think I went through 3 threaded rods before I got one bent just right.

 

Once you have it, screw a nut up a ways on it so that when ou screw it into the TB, it will stop when it hits the nut, and be in the perfect place everytime.

 

After you put the lid on, make sure the filter is seated up into the edge of the lid all the way around. You will be able to feel it snap in to place as you push around the edges.

 

If you don't get it seated in there good, you might have leaks. Then reset your PCM and drive it for a week or two. And I want to see pics.

 

Sorry for so many posts, that's the only way it would let me say anything. I'm done now.

 

Awesome, thanks Reid. I'll let you know how it goes when I try it again. Thanks for the tips.

 

This is to funny , REID , come over and rotate my tires .. cant figure out how to take the lug nuts off... start calling neon (GOMER)



SAAAAAAZAMEEEE !!!!

 

well, goooooollie!

PA,

We seriously need to consider opening up a shop in Maine. We could take them for a TON of cash, and I hear the summers are nice too.

 

You should just leave your truck alone neon. You don't really know what you're doing or what you want to do with it. What's the point of spending all this money when you're going to change your mind in a month?

Save your money, buy a house, or start smoking pot or something