When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
If your oil pressure is reading these after puting a manual oil pressure gage on the engine then the answer is yes the engine will have to come out and have all rod and main bearings replaced as well as the cam bearings.
Man, that sucks. Ok, so how imperative is this, I mean so long as the pressure doesn't just stop and I nurse the engine. Could it feasibly make it for a little while (about 4 months) before I yank it out and do the dang thing, i mean it has been doing this for two years with no other problems. What do ya' think?
Oh, and another question, what do I need to do to install a mechanical oil gauge? does it just screw into the old oil sending unit input. Or, do I need to tap into it somewhere else, if so where?