CB Install Image
Professional
Joined: Jun 2008
Posts: 172
Likes: 0
From: Plymouth PA
Yeah its a PC78 Elite, not a night watch radio though. It does have NOAA though.
The truck is used as a plow truck, thats why I have the switch panel. Right now I have Master, Front Strobe, Rear Strobe, Fog Light, Headlight Selector (Truck or Plow), and 2 empty banks for future add ons.
The truck is used as a plow truck, thats why I have the switch panel. Right now I have Master, Front Strobe, Rear Strobe, Fog Light, Headlight Selector (Truck or Plow), and 2 empty banks for future add ons.
Professional
Joined: Dec 2008
Posts: 100
Likes: 0
From: Boston
With the new truck, I went with a new setup.
Scanner and CB side by side.
Blurry, but that is behind the passenger seat. Fused power block and a gound bus.
Wilson 1000 with the offset stake hole mount to accommodate the tonneau cover.
Scanner and CB side by side.
Blurry, but that is behind the passenger seat. Fused power block and a gound bus.
Wilson 1000 with the offset stake hole mount to accommodate the tonneau cover.
Registered User
Joined: Sep 2010
Posts: 15
Likes: 0
From: CA
Hey Sully, can you post some pictures on how you mounted the units to your seat?
Professional
Joined: Dec 2008
Posts: 100
Likes: 0
From: Boston
I will get some pics after work, but I ended up dropping the money on a truck specific mount from Genos Garage. It was like $40 but works so good. It uses the two forward seat mounts. In my old Ram, I used similar mounting procedures and made my own mount. The pics are in this thread somewhere...
Captain
Joined: Dec 2008
Posts: 500
Likes: 0
From: Maysville, NC
I will get some pics after work, but I ended up dropping the money on a truck specific mount from Genos Garage. It was like $40 but works so good. It uses the two forward seat mounts. In my old Ram, I used similar mounting procedures and made my own mount. The pics are in this thread somewhere...