alright, i been waitin to do my exhaust until i got a welder, i ordered one and it came in today......its a cheapo gasless off of ebay......pretty sturdy but its only got high, low and wire speed settings, so its hard to get it right + i havent touched a welder in about 4 years also....i got a 7ft stick of 3" and an IMCO turbo from my local exhaust shop for $80 and a magnaflow ypipe for $40, for the o2 sensor i got a sparkplug nonfouler and cut it........not done yet......fixin to go back out and bolt it back up and put the muff on heres some pics......and yes a vid will be tomorrow

heres my welder


what i had left......ughh....btw, this sounded pretty mean, no joke


y pipe after o2 bung


heres the turbo


and heres where im at now

 

lookin good.. so if you dont mind me asking.. whatd ya pay for the welder.. ive been scoping harbor freight for one...

 

http://cgi.ebay.com/ws/eBayISAPI.dll...m=400029698952


it would be awesome if there was like a med or an amp control....on low it sputters and thers like no penetration and on high its hard not to burn through......i was usin .035 wire, dont know if .030 would have been better or not

 

oh, i got it on.....its just gonna be dumped for now......fixin to go for a spin

 

Dude check walmart out. I got both my welders there. I got a wire feed and a stick welder. They were pretty cheap too. Don't know how to weld to save my *** but I got welders

 

mine dont have any.....

 

just got back.... i like it, its not too loud tho......its got a pretty bad drone, so ill be runnin a pipe out the side.....sounds good when i get down on it

 

sweet!!! i have been whating to do that to my truck( cat rattles drives me fn nuts!!) where did you get the my pipe? and did you make the 02 port on it??

 

http://cgi.ebay.com/ebaymotors/ws/eB...m=260351990814

http://www.autozone.com/R,1456333/ve...ductDetail.htm

i couldnt find a 2" in and 3" out y so i put adapters at the in and cout off the end to make it fit.....for the o2 port, its just a 18mm sparkplug non fouler that i cut most of off......

 

sweet thanks, but what does the non fouler do?? does it make a thread hole for the o2?