took the dodge to get it inspected and on the way home on the passager
side floor it was linking antifreeze so i by passed the heater core.so i could drive the truck
know the truck won't start i have checked fuel pump spark and all of the ground wires. it want's to start but don't have that last ump to get it there
i should mention the engine has been all re done
2000 sport

 

So right after you did the by pass it would not start? Or did this happen at a latter time?

 

about a day later it stalled once and i got it running went up the rode with it and had to be towed home haven't been able to get it running sence

 

I would first make sure you didn't knock a sensor connector loose somewhere, when you were doing the bypass. The crank and cam position sensor elec.plugs are back there in that general location. I don't know what you did or moved around when you did the by pass. So at this point I would lean towards it being something like that for now.

 

might have bumped the coil wire, its right under the heater hose.

 

i check and recheck all of the thing you have talked about
still nothing.
it wants to start it just don't have that last ump to get it there

 

is the cel on? if yes post codes
post fuel pressure...psi?

do you have 12v at injectors 12v - good spark?

 

there was one code p-0463

 

p-0463 - fuel level sensor circuit, high input. check your fuel pressure at the rail, you may have a dead fuel pump.

 

u can here it come on