I finally was able to get the ram in the garage last night after some heavy cleaning and raising the garage door opening 3 inch's .now the truck wont fit all thew way in so i cant shut the door.

anyway I started the plenum task last night what a pain in the a##, what was dodge thinking, took me like 2 1/2 hours to rip it down just to get to the plenum.

I have found that not only was the plenum leakin so was the the front and rear gasket on the intake.

the timing chain all i can say i WOW holly **** it was loose

so since i am this far with the intake off timing cover off ,I may as well change out the oil pan gasket and rinse down the inside off the block.

 

what's it going to take to be able to shut the door. more raising ?

just keep thinking how much better its going to run when you're done.

 

no the truck fits under the door now it is just a little to long would have to move a wall and thats not going to happen so i guess I'll just push it in and out

 

Don't be a baby! Just cut the studs and put a nice bump out in the living room.

 

oil pan coming off?? I see a new oil pump with your name on it... then before you clean up that oily mess .... there is a trans cooler calling your name... ...

 

I saw the name of this thread and it scared me!!!

 

hehe, me too, was expecting something else

 

that's baaaaaaaaaaaaaaddddddd !

 

Dirty minds think alike.

 

man, at least your truck fits in a garage, pulling mine in would result in ripping off 3/4 of my cb antennas length

but i think it will fit in the carport at my apartment out in Illinois when i move out there next month