2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

just replaced 46rh tranny. now it wont shift out of 2nd

Thread Tools
 
Search this Thread
 
  #11  
Old 08-14-2010, 06:21 PM
andy_s273's Avatar
andy_s273
andy_s273 is offline
Registered User
Thread Starter
Join Date: Aug 2010
Posts: 23
Likes: 0
Received 0 Likes on 0 Posts
Default

i put 5 brand new quarts of atf+4. i just swapped it in. the fluids fine lol im scared to bust that 4500 rpm manuvre
 
  #12  
Old 08-14-2010, 06:23 PM
95RAM360's Avatar
95RAM360
95RAM360 is offline
Grand Champion
Join Date: Aug 2009
Location: MAINE
Posts: 5,971
Likes: 0
Received 45 Likes on 40 Posts
Default

it wont hurt it to do it once and a while...i remember a thread here a while back saying that its not good to baby these trucks, that you need to give them some sometimes...and 5 qts isnt enough....when i flushed i had to put 7 1/2 in each time....and thats with just dropping the pan....
 
  #13  
Old 08-14-2010, 06:24 PM
HeyYou's Avatar
HeyYou
HeyYou is offline
Administrator
Dodge Forum Administrator
Join Date: Apr 2010
Location: Clayton MI
Posts: 81,526
Likes: 0
Received 3,271 Likes on 3,018 Posts
Default

5 quarts in a rebuilt trans? It holds around 12 or so ya know......
 
  #14  
Old 08-14-2010, 06:56 PM
andy_s273's Avatar
andy_s273
andy_s273 is offline
Registered User
Thread Starter
Join Date: Aug 2010
Posts: 23
Likes: 0
Received 0 Likes on 0 Posts
Default

oh wow i feel stupid let me check.. well im low by maybe 2 quarts.... is it bad to mix atf4 with generic stuff im desperate now
 
  #15  
Old 08-14-2010, 09:29 PM
xjarhead69's Avatar
xjarhead69
xjarhead69 is offline
Record Breaker
Join Date: Nov 2009
Location: Leesburg, IN
Posts: 1,044
Received 0 Likes on 0 Posts
Default

Originally Posted by andy_s273
oh wow i feel stupid let me check.. well im low by maybe 2 quarts.... is it bad to mix atf4 with generic stuff im desperate now
Use ATF +4 ONLY! in your tranny.

Dave
 
  #16  
Old 08-14-2010, 10:33 PM
techmike's Avatar
techmike
techmike is offline
Rookie
Join Date: Aug 2010
Location: Anna, Tx
Posts: 98
Likes: 0
Received 0 Likes on 0 Posts
Default

^^ What he said...

It's obvious once you have the trans open whether or not the owner used ATF+4.
 
  #17  
Old 12-08-2017, 02:50 AM
85 dodge D150's Avatar
85 dodge D150
85 dodge D150 is offline
Registered User
Join Date: Oct 2017
Posts: 14
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by HeyYou
5 quarts in a rebuilt trans? It holds around 12 or so ya know......
i have 46rh transmission in 85 dodge D150 and it wont shift into 3rd
 
  #18  
Old 12-08-2017, 10:21 AM
HeyYou's Avatar
HeyYou
HeyYou is offline
Administrator
Dodge Forum Administrator
Join Date: Apr 2010
Location: Clayton MI
Posts: 81,526
Likes: 0
Received 3,271 Likes on 3,018 Posts
Default

Originally Posted by 85 dodge D150
i have 46rh transmission in 85 dodge D150 and it wont shift into 3rd
Check fluid level. (in neutral) Whens the last time the trans was serviced?
 
  #19  
Old 12-12-2017, 02:56 PM
85 dodge D150's Avatar
85 dodge D150
85 dodge D150 is offline
Registered User
Join Date: Oct 2017
Posts: 14
Likes: 0
Received 0 Likes on 0 Posts
Default

i haven't did it yet but i just bought transmission gasket and filter for it today.. what angle should my transmission be at, because im put 46rh transmission in 85 D150 and i had to make crossmember
 
  #20  
Old 12-13-2017, 12:14 PM
HeyYou's Avatar
HeyYou
HeyYou is offline
Administrator
Dodge Forum Administrator
Join Date: Apr 2010
Location: Clayton MI
Posts: 81,526
Likes: 0
Received 3,271 Likes on 3,018 Posts
Default

Should point down toward the rear diff a few degrees. If you don't get a vibration while driving, it's fine.
 



Quick Reply: just replaced 46rh tranny. now it wont shift out of 2nd



All times are GMT -4. The time now is 02:42 PM.