When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
thanks zman for the link, and thank you too hey you, I do like that I can use it on other vehicles also, so definitely will be going this route first... I will keep this updated on the results
Hey guys, so I went and bought the gauge, but I am not sure where this warning light sender is on the truck. And I was also wondering, should I get the T fitting so I can see the fluctuation on the cluster as well as the reading on the new gauge?
Sensor is at the back of the motor, just to the passenger side of the distributor. Hook the gauge up, doesn't have to be a permanent install, start the engine, and see what the gauge says.
alright thank you... I just remembered that I had bought a Chilton when I first got the truck, problem is I bought 1989 - 1996 ... but I figure it should be pretty similar to a 97
haha and thank you for your confidence matty, I assume thats bad and would need a new oil pump... actually thats a good question, what is normal for psi?