When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
No Pressure in Clutch Pedal...cant shift into gear
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
How did u get the clutch master cylinder past the brake booster? On mine it hits up against it right away
You have a Dakota, I suggest you ask your question in that forum here on DF. They are quite different. And may have clearance issues due to being a smaller truck. Some one over there might have a tip or suggestion.
I have a dodge cummins 2500. I'm having problems with my clutch not disengaging. I have replaced the clutch and pressure plate, throwout bearing, pilot bearing,and master and slave cylinders. I can't figure out what's wrong. Any ideas
The clutch pedal felt weak. When I pulled the trany back out I found that the fingers on the pressure plate where pretty much flat. Do they need to be or no? The hydraulics did come in one assembly.
I have a 1994 dodge cummins 3/4 ton that is haveing brake problems. It acts like some times it has power brakes and some times it doesn't. Then some times when it does have power brakes it seams like its weak power brakes.