I have a modded kegger with the aluminum plate already installed that im trying to sell... pm me getdown78 if youre interested.

That way all you have to do is swap intakes.

 

how much redneck ram ?

 

PM redneck_ram as he stated. This is not the thread for buying / selling.

 

Well so much for getting a plenum plate this week ! The guys ad on ebay says, out of town and won't ship till sept 10 ! Wasn't there a guy on here that sold a whole kit and not just the plate ?

 

I've got a plate, possibly a plenum too. PM me if interested.

 

http://www.hughesengines.com/Index/p...p?partid=27091

Unless you can go a different route.

 

Should i use the end seals that come in the gasket kit or beads of silicone ?

 

I've heard either, and both.
I believe the potential leak point is around the end of the end seals... so if not replacing the entire end seal with a silicone bead, at least apply silicone at the end of the end seals to avoid the leak potential.

 

And make sure, if you use the end seals, that the little holes the **** on the seal go in to are cleaned out.

 

Well i got the felpro intake set and it has cork type end gaskets not rubber ?