2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Weird miss

Thread Tools
 
Search this Thread
 
  #1  
Old 05-09-2011, 08:29 AM
dipsherry's Avatar
dipsherry
dipsherry is offline
Record Breaker
Thread Starter
Join Date: Feb 2007
Location: daytona beach florida
Posts: 1,091
Likes: 0
Received 1 Like on 1 Post
Default Weird miss

Ok if u get on my truck hard from a dead stop. It will miss terribley. And sounds like it is back firing. But if u lift up and ease into the throttle it is fine. could this b my coil. (i have the wonderful accel) I doubt its my injectors cause it just developed this problem.
 
  #2  
Old 05-09-2011, 09:16 AM
redheadhunter21's Avatar
redheadhunter21
redheadhunter21 is offline
Champion
Join Date: Apr 2007
Location: Miami, Fl
Posts: 2,831
Likes: 0
Received 1 Like on 1 Post
Default

I would start at checking the plugs and the wires, then cap and rotor.....also do you have any codes
 
  #3  
Old 05-09-2011, 09:17 AM
drewactual's Avatar
drewactual
drewactual is offline
Champion
Join Date: Aug 2010
Location: Cape Carteret NC
Posts: 2,697
Likes: 0
Received 3 Likes on 3 Posts
Default

because it's an accel, that would be my first place to look..
 
  #4  
Old 05-09-2011, 11:11 AM
97tn4x4's Avatar
97tn4x4
97tn4x4 is offline
Record Breaker
Join Date: Mar 2009
Location: Memphis, TN
Posts: 1,814
Likes: 0
Received 0 Likes on 0 Posts
Default

Maybe the tps not reading correctly?
 
  #5  
Old 05-09-2011, 11:12 AM
dipsherry's Avatar
dipsherry
dipsherry is offline
Record Breaker
Thread Starter
Join Date: Feb 2007
Location: daytona beach florida
Posts: 1,091
Likes: 0
Received 1 Like on 1 Post
Default

Sorry for double post stupid phone froze
 
  #6  
Old 05-09-2011, 11:14 AM
aim4squirrels's Avatar
aim4squirrels
aim4squirrels is offline
Legend
Join Date: Jul 2007
Location: DFW, Texas
Posts: 7,843
Likes: 0
Received 12 Likes on 12 Posts
Default

Its either air, fuel, or spark.

Verify fuel pressure at the rail at 49psi.

Check wires for loss of signal whilend checking ohms.
Visually inspect plugs, cap and rotor.

Swap coil for a known good one,

Then start looking at sensors.
 
  #7  
Old 05-09-2011, 11:14 AM
dipsherry's Avatar
dipsherry
dipsherry is offline
Record Breaker
Thread Starter
Join Date: Feb 2007
Location: daytona beach florida
Posts: 1,091
Likes: 0
Received 1 Like on 1 Post
Default

No codes cap rotor wires all look good. Guess stock coil is going back on tonight
 



Quick Reply: Weird miss



All times are GMT -4. The time now is 03:34 AM.