yea and thats what i did and no movement

 

OK, sounds like BJ's and hubs are good. Time to replace the ujoints. Should have NO play, up, down sideways.

 

ok how hard is this were talking about and what should i be looking to buy also should i do both sides or just the one making the noise

 

Bad u-joint....

 

BJs are always good!...oh, wait, different kind of BJ... :-)

 

Assuming that the u joints may have been installed at the same time (preferred method) and have been driven the same number of miles (unless front shaft on 4wd) I would replace all. Just to know that they are good...

 

Do you know how many times I almost commented on that?

 

u-joints and bearings DIY-
2 huge cautions - the bearings are very expensive, about $175 each, so if you have good ones, don't bust them during removal.

second - when re-inserting axles into the tubes - treat the axle seals like GLASS, as they are a lot of work to replace.

http://www.pavementsucks.com/tech-article-3.html
http://www.pavementsucks.com/tech-article-5.html