rough idle after start-up
#1
rough idle after start-up
ok guys,been a while since i have been on here but have a question....after i start my 2000 dodge ram 4x4 360 up after about a minute orso it starts to spit and sputter then runs ok and if i turn it off for twenty minutes or so and start it back up it does the same thing and it has that nasty smell too or maybe i just realized it....but anyway it only does it right after i start it up so far anyway...any ideas???
#2
#4
It's oxygen sensor season. Replace yours. NTK or Denso brands only.
To prove it out: At the point that it begins to spit and sputter, rev the engine to about 1500RPM and hold it there for 30 seconds or so. That will warn the upstream oxygen sensor with exhaust gas. Let up on the throttle and it should idle nicely again. If that happens, replace the sensor and drive happy.
To prove it out: At the point that it begins to spit and sputter, rev the engine to about 1500RPM and hold it there for 30 seconds or so. That will warn the upstream oxygen sensor with exhaust gas. Let up on the throttle and it should idle nicely again. If that happens, replace the sensor and drive happy.
#7
Trending Topics
#8
Ok well i checked my plenum and no oil pooling if thats what you mean by checking it...and will try giving it gas for 30 seconds after it starts to idle rough and see if thats it tomorrow and i have no codes...will check gas pressure on fuel rail too and is my fuel filter in my tank or not???
#9
Ok well i checked my plenum and no oil pooling if thats what you mean by checking it...and will try giving it gas for 30 seconds after it starts to idle rough and see if thats it tomorrow and i have no codes...will check gas pressure on fuel rail too and is my fuel filter in my tank or not???
#10
ok well i tried a few things on my truck...no codes not even on a scanner while driving...fuel pressure ok...cleaned throttle body and my mechanic said he tried that motor that is in the iac i think he said but that wasnt it...he said he did look down throttle body and noticed a little oil down there but not a lot...he thinks its the plenum gasket...he says he thinks its acting up when its first started up and after it warms up the plenum gasket kinda seals back up when it expands...what do you guys think about that???...sorry took so long to respond but a lot of things all going on at once right now!