96 Ram Starter will not come out!?
Thread Starter
|
Amateur
Joined: Sep 2005
Posts: 37
Likes: 0
Bad threads are at the start of the stud, so I can't get a nut started. It could have been corrosion. It was getting dark outside when I finally got it off. It didn't look too bad for corrosion though. So I really don't know why it was stuck on the way it was.
Grand Champion
Joined: Apr 2010
Posts: 5,011
Likes: 6
From: Meeker, CO
Got a hand grinder? If you're careful you can buzz down past the bad threads, dress up the edge, and thread a couple of nuts on there.
Hall Of Fame
Joined: Jul 2006
Posts: 12,204
Likes: 10
From: Gainesville, Ga.
got a die set. just thread it on gently and recut them.
http://www.harborfreight.com/60-piec...set-35407.html
http://www.harborfreight.com/60-piec...set-35407.html
