When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Bosch..... Yeah. These trucks simply do not like the bosch sensors. NTK or Denso only. Any other just cause more problems than you are trying to solve.
Bosch..... Yeah. These trucks simply do not like the bosch sensors. NTK or Denso only. Any other just cause more problems than you are trying to solve.
ok, I will try the ntk sensor should I replace the upstream one also? About the heater should it only have 12 volts for a second right when ignition is turned on or should it stay on longer? Also forgot to mention that the short term fuel trim for downstream sensor says 99% and doesn't move dont know if that has anything to do with this or not. Thanks
Yeah, replace 'em both. Heater circuit should see 12 volts for at least a few minutes.
ok, the auto shut down relay sends 12 volts for only a second when ignition is turned on with the sensor unplugged will it turn on longer with the sensor plugged in or is there a problem?
03-28-2020, 01:32 PM
