I used a 15/16 socket to press it in and figured it supposed to move since the old one was spinning in the socket lol..


but ya still cant get that god damn cap on frigin bs lol..


but ya used a 15/16 to press till I couldn't press any further and tried to hammer on cap no go still pissing me off

 

Did that particular 15/16" socket fit within the inside diameter of the yoke? If not, you need to find another socket that will fit to finish the press job.

 

sorry for delay.. and it was my mistake I wasn't using 15/16 it was 1" and it fits over and hammers that ball in I got it t move the ball accidently dropped hole thing on floor trying to make a video for you guys so it moves... but once again can not get that damn seal in even put it in the vice just like doing the ball pressing it in wont go in frustrating