When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
So, threw a p1762 trans code. Replaced the governed solenoid and pressure sensor. Reset codes and instantly came back. Unplugged upstream o2 since shared voltage, reset, Instant code. Faulty sensor? Bad trans internal harness? Parts are borg Warner so hard to believe DOA
P1762 Governor Pressure Sensor Offset Volts Too Low Or High
Get a scanner that reads live data and see what voltage the pcm is seeing.
I’ll take a look, now the sensor is the black rectangular one right? I didn’t have a code before I replaced it, the replacement of these two parts was due to trans limp mode with no codes.
11-18-2019, 11:16 PM
