Does anyone know the part number for the front axle( half shaft) u joint. Mopar number

kind of confusing cause front drive shaft also shows up.

last question if I don’t get mopar what is a good name brand. I put one on from orielllys non greaseable maybe name brand premium
It fell apart in no time (under 6 months) and I will pay extra to not have to do that big project anytime soon again.

 

Use spicer U-joints..... If you get the non-greaseable fellers, make sure they are WELL greased before installation. I don't have a part number handy though.....

 

Spicer 5-760x is OEM

 

Spicer 5-760X

If you happen upon some NOS 5-297's that's ok too

Greaseable is junk, I avoid whenever possible. Spicer says they put the correct amount of grease in each cup and don't add any. I still usually add a THIN layer to the rollers on D44's. Do NOT add to Dodge's weird crossover 5-811X because it blows out the hard plastic seals (rear pinion only on some years)

See also:

 

Sometimes ebay will have deals on 2-packs or here's Amazon link:

[url=https://www.amazon.com/Spicer-5-760X-U-Joint-Kit/dp/B009X1XDZG/]

Amazon

Amazon

 

Thanks all!!!!!

 

Get the spicer life series(SPL), They have a three lip seal.
https://www.danaaftermarket.com/sear...0&ymmType=AUTO