No gasket, just case against case. There's actually a weep hole, IIRC it's on the transmission side, so no reason to have a gasket.

 

thank you much, habe one more question for the day lol….

port pressure plugs….. blue loc tite or thread sealer or as is??

 

I would go with thread sealer.

 

That’s what I was thinking. Thanks bud !!

 

How much trans fluid should I dump in torque converter before installing in trans

 

About a quart will do, as I recall..

 

Another question. Should be done by Sunday. So that will be it lol. For this i job I HOPE!

hey are transmission mounts prone to go.
I was thinking if so I would just get one well it’s apart. Not the money I just didn’t want to buy a some cheapo and go back wards!

it downs took tore in half or anything .

thanks

 

When I did my '96 Ram 4x4 46RE transmission rebuild a few years ago, my transmission mount was in good shape, so I reused it. If it was questionable, I would have replaced it, but it was fine.

 

well mission accomplished.
rebuilt and installed!

whined for about 10-20 miles coming out of hole. Decided to manual shift with gear shifted and it was like a magic potion all worked out.

only missing one bolt. Bell housing to motor Dropped it when I had about 3 ft extension.
it will show up somewhere sounded like hit floor Jack. Anyway it’s the small one.
don’t want to pull one out to get size. anyone know how to get one or what size, length and thread pitch.

also thanks to the forum and help along with great video from transmission bench! Bought my kit there as well

 

Actually found a whole parts list like a manual type. So I have all bolt sizes I’m in need of. Th aka