Engine stalls when shift to drive
#21
RE: Engine stalls when shift to drive
The temp is running at 200 plus or minus a needle width or two. This just started to show on the temp gauge in the last week or so.
This is abnormal for the truck cause it usually runs at like 180/185 and the high is 200, it sits at 200 for a bit and jumps back down to 180.
This is abnormal for the truck cause it usually runs at like 180/185 and the high is 200, it sits at 200 for a bit and jumps back down to 180.
#22
RE: Engine stalls when shift to drive
ORIGINAL: CopperDesigno
I left it on. I sprayed the keck out of it with TB cleaner and its shiny now instead of the midnight black it was.
I left it on. I sprayed the keck out of it with TB cleaner and its shiny now instead of the midnight black it was.
when you go to put it back on, if you dont have a torque wrench, snug the bolts good but dont go gorilla nuts on it. the torque spec is something like 11~13 ft lbs IIRC and that is not much.
everyone here will tell you to yank it off, it's simple and will make your life alot easier.