Hey guys halfway through my replacement of cap rotar plugs and wires and i can't seem to get the rotar off. ANy suggestions it is also in the most inconvient place

 

mine was the same on my 99. i took an open ended wrech and fit it around the rotor and used a block of wood to lever it off. be carful though, not to bend the shaft

 

ok i got it off and replaced the wires etc but there was an extra wire in the box and idont know where it goes

 

Is it the new wire for the coil?

 

I think they all come with 2 coil wires, one with straight ends and one with 90 degree ends.

 

yep

 

yes i replaced the coil one that goes to the distributor it had 2 90degrees on it but theres another one with a 90 and a straight end

 

ok i think i got it figured out it's probably just a different ignition coil wire incase you got a different coil. Anyways runs much better with all the ignition parts replaced, cleaned the throttle body too, lots of gunk