Making your own Intake... Couple of questions...
Thread Starter
|
Rookie
Joined: May 2010
Posts: 58
Likes: 0
From: SW Virginia
Making your own Intake... Couple of questions...
The breather tube thingy that runs into the stock air box, what do you do with it?
And the IAT sensor, do you just drill a hole in the ABS tube and "bond" it with some RTV?
Thanks guys
And the IAT sensor, do you just drill a hole in the ABS tube and "bond" it with some RTV?
Thanks guys
For the IAT Sensor that's what most of the homebrew guys do. Or just use an appropriate sized grommet.
Last edited by lghtngblt02; Jul 14, 2010 at 01:18 PM.
Record Breaker
Joined: Aug 2007
Posts: 2,283
Likes: 2
From: live oak, ca
this is what i uesd for the valve cover vent, got it on ebay for about $5
BmJvOhCGkKGrHqQOKkIEtlS2hq8mBLem8br.jpg
BmJvOhCGkKGrHqQOKkIEtlS2hq8mBLem8br.jpg
Or just make a fitting on the intake tube...
all that is is a crankcase breather tube, right? Older cars used to just vent that to atmosphere, but pollution controlled cars have it going to the intake so the blowby gasses are burned. You can either put a vent cap like dodgetrucker or make a fitting on the intake tube to connect it to like lghtngblt says...