Led

 

I'm running these. cut 1 tab off, took about 10 seconds. no issues so far. http://www.ebay.com/itm/170915034945...84.m1439.l2649

 

So direct plug and play?
Thanks
STEVE

 

Nice! Thanks! Just ordered them. And the description says "non polarity" so the plug should work either way and be allowed to connect properly!

 

Yup. Direct plug& play. But like I said u have to shave off 1 tab w/ a razor or knife. Very easy mod

 

Just got these in the mail yesterday and popped them in this morning. The work great so far and the plug goes in normally. Hopefully I won't be having any issues with these. I found that the LED body for the original ones had become loose from the bulb base and was jiggling around. That's probably also why I had issues. And there was some slight rusting on the bulb power contacts. Most likely from the plug not being able to snap tight. Tossed them right in the trash.

Then today I got an email for these. And Xenon Depot is top quality stuff, so if I start to have issues with the new ones I have, I'll give these a try:
http://www.kbcarstuff.com/5202-H16-9...d-5202-led.htm

 

Looking good bro!

 

Did you have to trim the plug at all?
STEVE

 

Nope! Just shaved off the tabs. Plugged right in. I'll post pics this weekend after I wash it!

 

For the 2013 R/T it list this as the fog bulb PSX24W. So are they diff or is the 5202/H16 the same?????