Prerunner starting out! 3rd gen conversion with 37" deep dish
#1
Prerunner starting out! 3rd gen conversion with 37" deep dish
Greetings fellas. This is my first contribution... not sure it's worthy of much.
So I have a 2005 Ram 1500. Can't stand the stock look so I made some changes.
Purchased the Glassworks prerunner fender flares for the front, 06-08 model, which started my 3rd gen conversiona. $635 shipped to my door. Mounted up easily enough, large gap on left side and super tight on the right but not much I thought I could do about it.
Picked up a set of 37x12.5 nitto trail grapplers, had them mounted on fuel hostage 20x12 with -44 offset. Absolutely NO lift on this truck, but the fenders allow for up to a 37" with a leveling kit. I don't have the leveling kit I had to cut the pinch weld down flush with the cab on both sides and trim the fiberglass! It's SUPER tight, about 1/4" gap at full lock so I will do a little torsion bar crank action tomorrow.
Oh.. and I just finished a new paint job. Went from silver to Satin Black!!
Here's the pics.
So I have a 2005 Ram 1500. Can't stand the stock look so I made some changes.
Purchased the Glassworks prerunner fender flares for the front, 06-08 model, which started my 3rd gen conversiona. $635 shipped to my door. Mounted up easily enough, large gap on left side and super tight on the right but not much I thought I could do about it.
Picked up a set of 37x12.5 nitto trail grapplers, had them mounted on fuel hostage 20x12 with -44 offset. Absolutely NO lift on this truck, but the fenders allow for up to a 37" with a leveling kit. I don't have the leveling kit I had to cut the pinch weld down flush with the cab on both sides and trim the fiberglass! It's SUPER tight, about 1/4" gap at full lock so I will do a little torsion bar crank action tomorrow.
Oh.. and I just finished a new paint job. Went from silver to Satin Black!!
Here's the pics.
#7
Trending Topics
#8