I am trying to change the front hub bearing on an 05 3500 4x4.The manual I have tells me to remove the rotor (naturally) however the section on removing the rotor refers me to the section on removing the hub bearing. Now I feel like a piston in a bad engine. So a I decided to go off of instinct and remove the rotor from the axle, however it will not come off of the shaft [:@]. Any Ideas

Thanks in advance.

Frustrated owner

 

what manual are you trying to use? try going into this one and following their method

http://www.hemitruckclub.com/

scroll down and look on the left side...

 

if it is the same as a 1500,just did mine on monday,to remove the rotor remove the calitper and the cailiper bracket an slid the rotor off

 

could be a clip holding it on, should be easier to come at it from the outside. Every hub ive taken off, ive come from the outside, not the axle