Here it is. It is a Magellan Unit. It is the perfect placement. The bracket is actually the bracktron "semi custom fit unit". I got it at best buy. The custom bracketron bracket goes on the other side of the radio by the passenger side and is way too far away.

[IMG]local://upfiles/32260/02ECA4064E5541D0B0938E0071561AAF.jpg[/IMG]

[IMG]local://upfiles/32260/46091FF4BDDB4F9596D07D232C03D24C.jpg[/IMG]

 

A quick update for those of us with 6-spds...

The console comes apart very similar to the way this one did.

1) Pop out the rubber cupholders, and the black cap for what appears to be a manual transfer case lever, if I had one.
2) 3 8mm screws, 1 under the plastic cap (towards the back, the one you can see at first is easier to get at after this comes off), 2 under the rubber insert.
3) the back section of the console, behind the shifter, should now pop out. Theres a clip towards the front that might be stubborn, mine was.
4) 2 more 8mm bolts to remove the shifter cover. I just pulled it towards the top of the shifter and put the shifter in 4th to keep this panel out of the way, rather than remove the shift ****.

The rest of it is the same as Stratusguy's walkthrough starting at the second post (with the trim piece at the bottom, or behind the shifter in our case).

 

Thanks for the added info for the 6-speed guys. Hopefully this helps everyone.