I'm sorry guys, i know its another exhaust thread.....I'm just looking for ideas

Well inspection time is here and my truck will not pass with a dumped muffler. I was thinking sice everyone and there mother has duals out the back, that i would go with a single exit in front of the passenger tire. Now i DO NOT want the super Truck that Gibson offers, i dont like the look of the square tips.

I was going to make it myself, i'm taking the old flowmaster 40 series off and i wanna use a Super 44....I'm actually asking to see if anyone had any pics of some tip ideas.

I actually like the look of this one but its not a flowmaster, but atleast you can get the idea

http://www.youtube.com/watch?v=Y1qdT...eature=related

Thanks in advance
Ed

 

That's exactly what I'll be doing with mine as soon as my Aero Turbine gets here in the mail. I'm not sure what kind of tip I'll be using yet though. By the way, mail sucks. It's been three and a half weeks, and I'm starting to get edgy haha.

 

check the 3rd gen photo thread. I just put up a pic of my truck and its got what you're talking about but with dual tips.

 

Whats up Ed,
I did the exhaust in front of the wheel. Here in TX, as long as its 4 inches past back of cab, you'll be fine... not sure where you are. I attached (hopefully) a picture of my exhaust. Went for the dual side exit. I think it looks nice.... Its flowmaster 40. A little louder than I wanted... I get some drone in the cab especially around 2300 rpms. Nice... VERY NICE sound outside though.... Your call

Hope that helps,
Tex

 

Texasram01, i actually like that dual tip. Where did you get that or is it a kit?

 

thats the same as mine, but mine was custom from a local fab shop...

 

Ram MX i looked for your pic and i couldnt locate it, It said you only had 5 posts and 4 of them were in the lifted truck thread. Nothing about 3rd gen....

 

Not a kit. I got the muffler at Pep Boys... $80... Then a place called Xpress Automotive Service on 59 here in Houston installed and gave me the tips for $220. They do all the bending and welding there in the shop while I watched. Great group of guys if anyone in Houston ever needs exhaust work.

 

its in there. just go to the thread main page and its the top sticky.

"sticky: show us your 3rd gen"

 

Does anyone know where i can get that tip? ive searched online everywhere....
Ed