When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I've been reading this forum for years and your collective knowledge has been right on the money. I have an '04 1500 Hemi. When I stomp the pedal to the floor, instead of downshifting it stalls like a cutoff or limiter, yet well below 100mph cutout. It normally downshifts 2 gears and takes off like a bat out of hell. Now, when I push it all the way, it just cuts out and if held there, starts to buck. If I back off, it pulls normally thru 90% of powerband, but stalls out again when I push it to the floor. Anybody else seen this? Just started happening all of a sudden ... and everytime I floor it. Will this produce an error code and if so, how do I get the code? What do I look at first? Any suggestions will be appreciated.
There was a thread detailing the method by which the cockpit requested Scotty to send more power from the engine room. Some linkage runs from the pedal to the engine room which is translated as a command for more warp power. If'n I think about it tomorrow night, I'll see if I can find it in the manual.