When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
where is the air sensor located at for the air intake? i thinks thats what its called, o yeah im goint to remove my air box to install the cold air intake,
i thinks its called the mass air flow sensor.
Do i need to disconnect my battery to reset the ecm?
where is the air sensor located at for the air intake? i thinks thats what its called, o yeah im goint to remove my air box to install the cold air intake,
i thinks its called the mass air flow sensor.
Do i need to disconnect my battery to reset the ecm?
No Mass air flow sensor its an air temp sensor. Its the only wires that are on your intake. Be careful when removing and installing it because its a bit brittle...
No Mass air flow sensor its an air temp sensor. Its the only wires that are on your intake. Be careful when removing and installing it because its a bit brittle...
i dont see any wires or anything on the stock intake! or am i blind?
in the middle, towards the back of the engine. says hemi on it. just on the front side of that is the plug. its small, only 2 wires and like previously stated be kinda careful with it.
in the middle, towards the back of the engine. says hemi on it. just on the front side of that is the plug. its small, only 2 wires and like previously stated be kinda careful with it.
all i did was take the old one out and put the new one in i didnt see no cables nor conectors or maybe im blind, also why did i have to disconnect tha battery? what happens if you dont?