ok im at a loss, i have a rough idle while in gear, hesitation on acceleration, codes p0113, p0123, p0132, p0222, p2111 and p2106 i have changed the o2 sensor, the map sensor, removed and cleaned the throttle body, reset computer and codes come back after a couple of days of driving and the acceleration issue returns, before i spend the money on the throttle control is there anything else i could try, please help, thanks in advance, oh i guess you should know its on a hemi 5.7l

 

Welcome to the site. I will move this thread to the correct section if you tell me the model and year of your Hemi,
FF

 

oh thanks, 2003 dodge 3500, 5.7l hemi

 

I will move the thread to the third generation Ram section,
FF

 

P0113 Intake Air Temp Sens Voltage Hi
P0123 Throttle Pos Sens Voltage Hi
P0132 1/1 O2S Shorted To Voltage
P0222 APP Sens2 Circ Low Voltage
P2106 Throttle Actuator Ctrl Sys-Forced Limited Power
P2111 Throttle Actuator Ctrl Sys-Stuck Open

Check your electrical connections for shorts, make sure you installed your new sensors correctly and calibrated them.

 

please excuse my ignorance, but just how do you go about calibrating an O2 sensor

 

You can't, ignore the "calibrate" part of my post, I thought you installed a new TPS sensor as well. Although you should check to see if you damaged the TPS when you cleaned the TB.

 

well its my understanding that the TPS is incased within the TB so i dont think i could damage it, please correct me if im wrong