Eaton Supercharged 5.7 Ram
on an all stock hemi how much boost could you safely run? I am paying for the lifetime powertrain warranty which will replace my engine if it were to blow up. If it were to blow up with a supercharger on it, couldnt i just remove the supercharger and put it back to stock then have it towed into the dealer? Would they still be able to prove it was on there? What happens to the trans and driveline after so long with the supercharger on there? Are there any irreversible installation pieces?
Yeah, try to make Dodge pay for something you screwed up. That's the spirit of the warranty
Then the rest of us get to pay for it in the form of higher vehicle prices.
How about accepting personal responsibility? When you play, ya gotta pay. If you've got the bucks for the blower & install you should have the bucks to replace the engine if you screw it up.
Then the rest of us get to pay for it in the form of higher vehicle prices.How about accepting personal responsibility? When you play, ya gotta pay. If you've got the bucks for the blower & install you should have the bucks to replace the engine if you screw it up.
well... the manifold is the most expensive part everything else is within reason... heres a list of estimated cost envolved
Supercharger.......3-600.00
manifold..........1,000.00
custom top plate 350.00
Intercooler.......500.00
heat exchanger......2-300.00
intercooler pump...... 80.00
misc hoses, brackets, fittings........... 1-200.00
mater meth kit........... 3-400.00 (optional)
efan..........2-300.00
pulley setup bracket....... dont know yet
adaptor plate for tb...........dont know yet
im not done yet with this project so I dont know exact prices but I will be resuming working on this once my forged motor arrives and is installed...
If anyone really likes what im doing here and wants to come on board as a partner in this pm me
Supercharger.......3-600.00
manifold..........1,000.00
custom top plate 350.00
Intercooler.......500.00
heat exchanger......2-300.00
intercooler pump...... 80.00
misc hoses, brackets, fittings........... 1-200.00
mater meth kit........... 3-400.00 (optional)
efan..........2-300.00
pulley setup bracket....... dont know yet
adaptor plate for tb...........dont know yet
im not done yet with this project so I dont know exact prices but I will be resuming working on this once my forged motor arrives and is installed...
If anyone really likes what im doing here and wants to come on board as a partner in this pm me
Last edited by blownhemiram05; May 2, 2010 at 05:17 PM.



