Long time member on DT but new here... Thought I would post up a few pics of my project... Any question feel free to ask.

 

I was following this thread over there for awhile, did you get it working? I'm alot more active here (so I haven't looked over there in awhile).

 

you befouled a hemi by putting a Furd product on it. haha

that thing is going to scream once you get it going.

 

that's awesome. i would love to see you race a lightning, and see the guys face when you open the hood

 

lots of work. Just make sure you keep that thing cooled because the Eatons do like to produce loads of heat. An exellent performer on a stock block for sure. You got any work done to the block or heads?

 

Take a look at the thread over at DT, it's like a 100 pages long, including AIR RAM showing the same blower adapted to a 4.7, which apparently has a deep enough valley 'tween the heads to keep the cooler that goes under that blower.

 

badass man

 

Got any videos of that truck running? How does it perform?

 

The ford logo will be gone once the snout gets lengthened... also the manifold is designed to fit a intercooler in it just like the cobras...
It is not done yet due to the fact I got offered money for my motor(sold for 950.00) and currently one is being built by STU at Inertia...
Its just gonna be a 5.7 with 6.1 crank, K1 rods and Manley 9.5.1 CR self ported/polished heads with manley intake and exh valves (stock size) and 6.1 Exh springs

 

392 stroker supercharged????