WELL i know there is a 1000's threads on making a d.i.y power wire but iv got it in my mind to find the 2 connectors that airram uses for there plug and play powerwire.
So i found the 2 mopar p/ns this one is the repair kit

> IAT connector repair kit P/N 05017119AA $31.80 cdn
>sensorMopar Package #05014003AA SENSOR-INTAKE AIR TEMPERATURE (GAS) - DK. GRAY (ENGINE) 2 WAY

CAV CIRCUIT FUNCTION
1 K21 20DB/LG IAT SIGNAL 2 K900 20DB/DG SENSOR GROUND
i went to 3 differnt auto parts wholesalers to find the correct replacement pigtails but no luck i talked to 2 different dodge dealers in my hometown but thats like talking to a 12 year old kid with A.D.D

so if anyone knows that type/make/pin type for these connectors would be very much apreciated ....PP

 

just found this wich will be helpfull down the road

http://www.dodge.com/bodybuilder/200...torpinouts.pdf

 

I did not use any connectors. I cut both wires, and soldered a few inches of wire into each side, and added the resistor to one of them. I also soldered in a second wire alongside the resistor wire and put solderless plug terminals on them so I could swap between the two. So far no problems.

 

spending 30.00 defeats the purpose of diy you can find them for that all of the time

 

Either buy a used power wire from the classifieds as they come along or go get (5) resistors from RadioShack for $1.

On a side note, Im going to RS today to pre-order my HTC Evo. LOL

 

I hate you.

To the OP, no need to buy the OEM like connectors, its just an added expense. Radioshack that thing together

 

Thats ok BIOTCH because Im going to use that phat azz 8mp cam and do some shots of the truck and post them along with vids.....!!!!!!



Did I mention Im getting two of them? One for me and one for the wifey.

 

i hate her too. I waited to get the hero (hoping for 2.1) but then got tired of waiting, and they announced it was doing to upgrade old ones to so picked it up. a month later EVO gets announced

hate your wifey too

/threadjack

 

Ok, no more thread jacking.....PM sent

There is hope for you yet brother