ok here is my problem i got headers and cat the o2 sensor wont reach i think either i should get non foulers or should i get the
http://airram.com/product.php?catego...rchquery=Dodge
because with non fouler you have to drill holes correct?

 

If I understand what you are asking is what is done when the sensors wire is too short? Cut the wires and add a section to them so they reach. I moved mine today and was lucky that all that was need was to cut a retainer for the back one to reach.

 

ya i did that still dont reach stupid me did not read other post idk waht to do either non fouler is when i put the o2 sesnor in but i got to re drill a hole or use the extender but all four of them dont fit

 

The hole you need to drill is just in one of the non-foulers, take you 30 seconds. As far as the wires, just cut and splice...

 

got it all figured out at moes he said dont cut the wires lol i got 3 extenders i am going to use

 

i hope this isnt your quote
http://torqueaddicts.net/forums/showthread.php?p=190001

 

I cut, spliced, soildered, heat shrinked and wire loomed one of mine and no issues.

 

of course he's going to tell you to not cut the wires and BUY EXTENDERS FROM HIM...

Either will work, one just costs a little more...

 

I used extenders from Moes on some of the wiring for my o2 sensors when I did my headers. The extenders only fit the front o2 wiring but did not fit the rear o2 wiring.