3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

Power lock problems

Thread Tools
 
Search this Thread
 
  #1  
Old 12-30-2010 | 04:24 AM
foxracer's Avatar
foxracer
Thread Starter
|
Registered User
Joined: Dec 2010
Posts: 3
Likes: 0
Default Power lock problems

Hey, new to the forum, I have a 07 Ram 1500.

A few months back, the power lock for the rear drivers side door stopped working...kinda a pain but something I could deal with. Now tonight, the drivers door power lock stopped working too, with the key fob and the switch inside the truck....both are dead. The passenger side (front and rear) still work fine with the switch and key fob. Any ideas on what the problem could be?

Thanks.
 
  #2  
Old 12-30-2010 | 08:32 AM
weedahoe's Avatar
weedahoe
Hall Of Fame
Hall of Fame Member
Joined: Mar 2009
Posts: 19,168
Likes: 21
From: South GA
Default

Either broken wires in the door looms or dead latch/lock assemblies.

2007 DR QC latch assembly P/N for both drivers side (with RKE) is 55276791AG and is $31 on www.wermopar.com

Here is a "How To" on it

http://tinyurl.com/2afggxk
 
  #3  
Old 12-30-2010 | 09:33 AM
foxracer's Avatar
foxracer
Thread Starter
|
Registered User
Joined: Dec 2010
Posts: 3
Likes: 0
Default

Thanks for the quick response. Is there a way of telling if its the part you mentioned or a wire break? I'm guessing if i got everything taken apart and just checked if there was power going to it, that should tell me, correct?
 
  #4  
Old 12-30-2010 | 02:47 PM
weedahoe's Avatar
weedahoe
Hall Of Fame
Hall of Fame Member
Joined: Mar 2009
Posts: 19,168
Likes: 21
From: South GA
Default

You just have to pull back the rubber loom from the door to the body and check those wires. Because they move back and forth with the doors sometimes the break
 
  #5  
Old 12-30-2010 | 07:05 PM
foxracer's Avatar
foxracer
Thread Starter
|
Registered User
Joined: Dec 2010
Posts: 3
Likes: 0
Default

Ok, i got everything apart, got the wiring harness disconnected. Only time i get power to it, and to just one of the 4 pins, and only when i hit the unlock button. I'm guessing there's a break in a wire somewhere then.
 




All times are GMT -4. The time now is 01:42 PM.