Hey Guys,

I know it may be asking kinda a lot, but my buddy is an engineer at Warren, MI truck plant and is looking things up for me in regards to my possible 1500-Power Wagon swap/conversion. The system in which he is using needs manufacturer part numbers...What I did to get him my numbers was crawl under the truck and snapped a pic with my phone of the tag on the front axle then pic messaged it to him cuz there were a couple different numbers on it. So what I need is this part number from a 2500, Hemi if it matters...not sure if CTD has bigger axles or not. If it's easier than writing them down while under the truck, snapping a pic like I did will work and PM me for my email or phone number to message it to me...It will be MUCH appreciated.

Thank You in Advance!!

 

they are 9.25(front) and 10.50(rear) AAM axles for the Hemi(2500's)
and 9.25 and 11.5 for CTD

 

Ahh, ok, so it doesn't matter for the front axle, which is the numbers I need. Thanks for that bit of info.

 

I don't think it matters,but I don't know that for sure.

 

My hemi 04 has a 11.50 rear axle, i guess mine was a special order? has 4.10's

 

I don't think you have a 11.5 rear axle....only the CTD's have them.
I too,had 4.10's from the factory(10.5 rear)and then I had them switched to 4.56's(still a 10.5 rear)

 

It says 11.5 right on the build sheet in the glove box 4.10 ratio. Above it is 10.5 delete.