Installing E-Fan, any Tips?
#11
#12
No I don't have any pictures of the wiring or the sensor, I will take come pictures tomorrow and post them up. It came out really good. FWIW, I ended up not soldering any of the connections, they are all crimped and heat wrapped and or electrical taped. This made the install quick and painless.
#13
Why are people using fan controllers? I just bought a fan temp switch for a Taurus 185 on 178 off I think was its spec. run the wire from the fan switch to the ground side of the relay pole. Let the relay kick the fan on at those temps.. fan temp switch was like 12 bucks at Oriellys plus the heavey duty relay and some wire.. was a LOT cheaper and very reliable setup.. had the same setup on my 78 F150 Big Block for years with dual fans.. It may still have that setup for all I know.. sold it that way.
#15
That is what the fan temp switch is, it screws right into the manifold, in my case thier was a threaded plug in the thermostat housing, pulled the plug and put the switch in that hole.. works like a charm.. All they do is ground the relay so it turns on the fans at given temp.
Like this.
http://cgi.ebay.com/ebaymotors/COOLI...item1e662d84f4
Like this.
http://cgi.ebay.com/ebaymotors/COOLI...item1e662d84f4
Last edited by Plainbroke; 08-21-2011 at 02:09 PM.
#16
#18
#19
#20