transmission limp mode - DodgeForum.com


Notices

3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

transmission limp mode

Reply
 
 
  #1  
Old 08-21-2011, 10:14 PM
cjk
cjk is offline
Registered User
Thread Starter
 
Join Date: Aug 2011
Posts: 7
Default transmission limp mode

Hi I am new to the site and was hoping that someone could help me out. I have a 2004 hemi ram 1500 with 105000 mi. the problem is that it will get locked in third gear and not shift up or down I can manualy shift it to second but it will not go into first at all. If i turn the key off and restart it it will shift fine for awhile then back to locked in third. Last fall I had the check engine light come on and took it to a dealer and 80 bucks later they told me the light was on because the transmission controller lost power but it was fine now and they had no ideal what happened. I figured i would get an opinion on the issue before i took it to the dealer again. thanks for any help
clayton
Reply With Quote
  #2  
Old 08-22-2011, 12:30 AM
scwpd
scwpd is offline
Veteran
 
Join Date: Jan 2010
Location: Williston,sc
Posts: 410
Default

is it throwing any codes now?
Reply With Quote
  #3  
Old 08-22-2011, 07:47 AM
weedahoe's Avatar
weedahoe
weedahoe is offline
Hall Of Fame
Hall of Fame Member
 
Join Date: Mar 2009
Location: South GA
Posts: 19,154
Default

^^^ agreed. You are going to have to go to an auto parts store and either let them pull the codes or find someone with an OBDII scanner and pull them. Please post your codes when you get them. Without the codes we can't tell you anything but broad and general information.
Reply With Quote
  #4  
Old 08-22-2011, 10:58 AM
cjk
cjk is offline
Registered User
Thread Starter
 
Join Date: Aug 2011
Posts: 7
Default

I stoped at a local shop this morning and the code was for a LR (low reverse) solenoid, sorry should have done that first was just anxious to get ideals. the scanner also said it could be a bad ground or the tcm. I downloaded the service manual and cannot find were this solenoid is located my guess would be by the valve body but I am still in the prosses of gatering information. thanks
Reply With Quote
  #5  
Old 08-22-2011, 12:19 PM
weedahoe's Avatar
weedahoe
weedahoe is offline
Hall Of Fame
Hall of Fame Member
 
Join Date: Mar 2009
Location: South GA
Posts: 19,154
Default

If you post the actual code I can then post all the trouble shooting steps and diagnostics
Reply With Quote
  #6  
Old 08-22-2011, 03:47 PM
cjk
cjk is offline
Registered User
Thread Starter
 
Join Date: Aug 2011
Posts: 7
Default

P0750
Reply With Quote
  #7  
Old 08-22-2011, 09:27 PM
cjk
cjk is offline
Registered User
Thread Starter
 
Join Date: Aug 2011
Posts: 7
Default

it looks like I will have to replace the selonoid my question is will i have to do a quick learn for the tcm after the parts are changed? weedahoe I would still like the troubleshootin list just to be sure. thanks

Last edited by cjk; 08-22-2011 at 09:29 PM. Reason: spelling
Reply With Quote
  #8  
Old 08-22-2011, 10:59 PM
daytonatransmissionservice
daytonatransmissionservice is offline
Registered User
 
Join Date: Aug 2011
Posts: 1
Default limp mode 3rd gear

HI...my name is roger i own an automatic transmission shop...
seems to me like your solenoid pack just went out...along the years they start to put in the dodge caravans,sebrings etc...basically passenger cars
up until 2003-2004 dodge ram change the transmission it used to be 518-618 in diesel engines...

i just need to know if its a 5 spd auto or 4spd...
there are 2 kinds of solenoid packs
black conector
white conector

to replace one of those ones you will have to take tha pan off and pull the valve body....transmission parts are around 250 for a new one and also updated

if im right when you turn the key off...gets out 1th gear when you go to a stop light boom...a limp mode...and other situations...

a good and used one can cost you 50 bucks...and relearn can be done by scanner or driving...

im positive if is not the 518 so you will have to replace the solenoid pack..
if is the 518 so your problem is not a solenoid...
theres no solenoid call low-Reverse for that one theres just 4 solenoids
wich are... lock up-o.d-pressure sensor-and gobernor pressure...

so if im right its gonna be the solenoid pack on either 5rf55e or 4rf55..i dont remember the name of that transmission....any more questions i might help go to daytonatransmissionservice.com and send me an email..

Roger
Daytona Transmission Service
Hillsboro Or
Reply With Quote
  #9  
Old 08-22-2011, 11:04 PM
weedahoe's Avatar
weedahoe
weedahoe is offline
Hall Of Fame
Hall of Fame Member
 
Join Date: Mar 2009
Location: South GA
Posts: 19,154
Default

it seems I currently do not have access to my software but try this link

https://dodgeforum.com/forum/3rd-gen...m-alldata.html
Reply With Quote
  #10  
Old 08-22-2011, 11:18 PM
cjk
cjk is offline
Registered User
Thread Starter
 
Join Date: Aug 2011
Posts: 7
Default

thanks for the help it was much appreciated. now to order parts
Reply With Quote
 
 
 

Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
sniper82
Dodge Caravan
5
08-10-2015 06:45 PM
wilfrids
Dodge Caravan
4
07-26-2015 09:35 PM
willie101474
Dodge Neon
1
07-26-2015 01:37 PM
rickybobby2189
Dodge Caravan
4
07-24-2015 06:53 PM
eagle101
2nd Gen Ram Tech
2
07-12-2015 10:43 AM


Thread Tools
Search this Thread

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Forum Jump

Featured Sponsors

All times are GMT -4. The time now is 06:50 AM.