Badly Rusted Hub Bearing ????
Thread Starter
|
Registered User
Joined: Dec 2011
Posts: 5
Likes: 0
well i finished up around 5 pm got it out finally,
wanted to post pictures of what i did to get it out but there's no icon for it here
http://share.shutterfly.com/view/fla...d=8Kcs2zRsyZwg
so here's a link to my shutterfly
Yes i clean it all up with wire brush and coated all mating surfaces with anti sieze so if i have to replace the u joint it will come apart easy next time
notice i ground a notch on both sides to put the puller in place it did heat it up some but not to cherry red since i don't have a oxy-ac torch yet.
wanted to post pictures of what i did to get it out but there's no icon for it here
http://share.shutterfly.com/view/fla...d=8Kcs2zRsyZwg
so here's a link to my shutterfly
Yes i clean it all up with wire brush and coated all mating surfaces with anti sieze so if i have to replace the u joint it will come apart easy next time
notice i ground a notch on both sides to put the puller in place it did heat it up some but not to cherry red since i don't have a oxy-ac torch yet.
Last edited by roadstar30; Dec 10, 2011 at 10:34 PM.