When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
My 06 1500 Quad is having an issue with its cruise Control. I cant say it doesn't work at all but it only works between certain speeds. 40-45 then 65-70. Other then that the light wont even come on if say I was going 50. Any ideas? Thx in advance!
Had the same problem ended up being the from Left wheel bearing hub assembly . The speed sensor for the cruse control is located in the hub, that’s what causes the issue
make sure the wheel speed sensor (L Hub bearing) is pluged in. Check the pins, water in the connector. Cruise control gets its signal from that wheel sensor. Poss the sensor went back. Where did you get the hub from? maybe a warranty
On my 04 had both. I ran 285/70/17 tires. Truck came with 3.55 gears. Had 4.56 installed for towing. Changing tires size will effect the speedo, gears will not mine was 5mph lower than actual speed.
It just occurred to me that I installed a superchips programmer that supposedly adjusted the speedo for my 35" tires. I am now thinking this adjustment threw everything off. Cruise worked before re-calibration.