3rd Gen Ram Tech 2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

no crank no start advice needed

Thread Tools
 
Search this Thread
 
Old Apr 24, 2017 | 07:01 PM
  #1  
David2022's Avatar
David2022
Thread Starter
|
Registered User
Joined: Apr 2017
Posts: 4
Likes: 0
Default no crank no start advice needed

2003 Dodge Ram 1500 360 motor
sat through winter went to start it battery was dead
replaced battery with new tried to start. Truck now has no dash warning lights only shows odometer and gear select fuel pump doesnt engage no crank no start overhead center has no display radio will come on but has no sound flashers work interior lights work I also replaced ignition switch any suggestions? I'm at a loss at this point
 
Reply
Old Apr 24, 2017 | 07:36 PM
  #2  
p38251's Avatar
p38251
Record Breaker
Joined: Feb 2011
Posts: 2,001
Likes: 0
From: Vanderpool Texas
Default

Check fuses and relays. Look for critter damage
 
Reply
Old Apr 24, 2017 | 07:56 PM
  #3  
David2022's Avatar
David2022
Thread Starter
|
Registered User
Joined: Apr 2017
Posts: 4
Likes: 0
Default

Fuses are all good as far as I can see any specific ones I should double check? and I looked pretty much every where for nests nothing I even went as far as tearing the dash apart to find anything that could lock me out
 
Reply
Old May 3, 2017 | 02:53 PM
  #4  
BigHorn70's Avatar
BigHorn70
Rookie
Joined: Mar 2016
Posts: 70
Likes: 3
From: Tournai - Belgium
Default No crank

check ground motor
 
Reply
Old May 10, 2017 | 09:31 AM
  #5  
David2022's Avatar
David2022
Thread Starter
|
Registered User
Joined: Apr 2017
Posts: 4
Likes: 0
Default

Still having this issue I can put power to the starter from the ignition with a outside power source and crank just fine. I have power everywhere I should to the ignition just no dash lights no crank no fuel pump could the ignition switch be faulty? Could the immobilizer be bad? My obdll port is also dead we tried putting a computer on it and nothing
 
Reply
Old May 10, 2017 | 09:51 AM
  #6  
TNtech's Avatar
TNtech
Site Moderator-Dodge Tech
Joined: Sep 2010
Posts: 3,724
Likes: 22
From: Nashville, Tennessee
Default

Originally Posted by David2022
Still having this issue I can put power to the starter from the ignition with a outside power source and crank just fine. I have power everywhere I should to the ignition just no dash lights no crank no fuel pump could the ignition switch be faulty? Could the immobilizer be bad? My obdll port is also dead we tried putting a computer on it and nothing


It could be bad. Take your battery terminals OFF and tie them together for about 30 minutes. Make sure the battery is charged before you do this because if you reconnect the terminals to a dead battery, it might put the module back to sleep again.


FYI, most of the time the OBD connector power and Immobilizer module are on the same fuse.
 
Reply
Old May 10, 2017 | 10:15 AM
  #7  
David2022's Avatar
David2022
Thread Starter
|
Registered User
Joined: Apr 2017
Posts: 4
Likes: 0
Default

I will try it and we checked every fuse in the block with a voltage meter
 
Reply
Old May 13, 2017 | 11:39 AM
  #8  
TNtech's Avatar
TNtech
Site Moderator-Dodge Tech
Joined: Sep 2010
Posts: 3,724
Likes: 22
From: Nashville, Tennessee
Default

Originally Posted by David2022
I will try it and we checked every fuse in the block with a voltage meter


Use a standard test light for that. Both sides of the fuse.
 
Reply




All times are GMT -4. The time now is 08:08 PM.