When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
RE: rear gears? whos got em, and where did u get em
3.21 are stock for my 2005 ST V6. I am sure it is for all V6. If I would have known, I would have asked for a 3.55 or 3.92. The 6th gear helps with the RPMs. It was only $50 more, now it would cost $500-$1000 to do it.[:@]
RE: rear gears? whos got em, and where did u get em
what about 4.10s i think that 4.56 would be to high for a normal truck, even though my truck now will do 90 mph at 2700 rpm, how do i figure out what it would be with 4.10s
RE: rear gears? whos got em, and where did u get em
I dont have a sticker in my glove box, cant find anything in my owners manual either. Im assuming i have around 3.55 though. Whats the largest saize that can fit in these axles? i know 4.88 in a dana 35, so it must be at least that.
RE: rear gears? whos got em, and where did u get em
yeah 410s sound good, hemi man, on a scale of 1-10, how hard are rear ends to work on, iv replaced the spider gears and axle shafts in chevys, but that is it, do you think its worth the instalation money ill save to do it myself?