no wonder Toyota is best selling!!!!!
#22
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
Backwards Damn!!!!!!!!!!! No Really its a single in dual out, if they get that wrong than they should go back to bicycles. As for the PCM its been reset twice to no avail.If I remove the mods and the truck runs right then what do i do with the mods, install it on my snowmobiles??
#23
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
All wheel drive? I haven't heard of that on dodge ram's yet. That would suck if you liked to do a few burn outs. My buddy's wife has a ford escape that's like that, AWD and 4wd. He says in AWD it doesn't kick in and he ends up putting it in 4 HI anyway.
Mods are always good to do one at a time, then when there's a problem it's easier to find .
Mods are always good to do one at a time, then when there's a problem it's easier to find .
#24
#25
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
ORIGINAL: cwbyup04901
......Bought an 04 1500 Laramie 4x4 QC with 12k miles......What $30 / per hour to work at the factory isn't enough to turn out good quality .
......Bought an 04 1500 Laramie 4x4 QC with 12k miles......What $30 / per hour to work at the factory isn't enough to turn out good quality .
ORIGINAL: cwbyup04901
What a year 2 trucks and both are piles of junk.....
What a year 2 trucks and both are piles of junk.....
ORIGINAL: cwbyup04901
had truck 2 weeks and installed K&N CAI and Flowmaster American Thunder Cat Backs. Truck has run like crap since then....
had truck 2 weeks and installed K&N CAI and Flowmaster American Thunder Cat Backs. Truck has run like crap since then....
#27
#28
#29
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
I would check the connections on teh CAI as mentioned earlier. As for the exhaust "leak" noise that you are hearing....it could be the flowmaster itself. I have seen this happen before where the muffler was defective and the baffles inside the muffler were screwed up from the factory.
As for the comment about engineers, I know I don't make nearly as much as I should.
As for the comment about engineers, I know I don't make nearly as much as I should.
#30
![Default](https://dodgeforum.com/forum/images/icons/icon1.gif)
I haven't put any mods on my 04 RAM 1500 SLT w/the HEMI and my truck is still good from 0-50....but i am experiencing the second problem he stated......when iput the pedal downitrevs real high and then rockets into gear.....well the word rocket is a bit drastic...still I love the truck but if anyone knows what that might be i am listening egarly......and even with my problems i think i could still destroy that yota.