Well I got a good one !!!! I was installing a cb radio and I was installing it on the dog house in between the console and the middle seat ..I stuck my hand underneath the carpet and did not feel any wires in that location.so I went back to the tool chest and got some screws and went to mount it !!I must have moved the mount at one point because I screwed threw a wire harness!!!!!now the truck 2013 Ram 1500 5.7 L ..dash just flashes no start ,no lock ,not a thing ..so I found said harness and found 4 wires I cut ..I unplugged the + battery and wired them back to each other with wire clamps .. now the truck starts runs for 30 seconds and shuts off and the dash starts flashing and codes start going off low fuel ,air bag, traction control ,and so on ..any advice ?

 

Wonder if it shorted something out when you had power to those wires......

Check your owners manual for the procedure to reset security after the battery dies. I suspect that is at least part of your problem.

Moving this to 4th gen ram section for ya.