97 Caravan Stalls, Code P0108?
Thread Starter
Joined: May 2007
Posts: 1
Likes: 0
97 Caravan Stalls, Code P0108?
97 Caravan 3.0 : MAP sensor fault? Code P0108
250,000 km
This has been going for a month or so, the dealer replaced the MAP sensor ,
the problem came back in a week, the dealer repaired the connector at the
computer (no charge)
2 weeks later it has come back with service light, took it back, the dealer said the error was the same as before, but the van was /is working. They reset the error (no charge). Let's monitor
Today the error is back, the van is very hard to start, it stalls unless you
press on the gas. It has stalled on the wife when driving aswell. .Presently the Service light is back on, it went off earlier today.
It also seens to "miss" while driving.
Any thoughts, it old and this is an intermittent issue which makes it
tougher.
Russ
250,000 km
This has been going for a month or so, the dealer replaced the MAP sensor ,
the problem came back in a week, the dealer repaired the connector at the
computer (no charge)
2 weeks later it has come back with service light, took it back, the dealer said the error was the same as before, but the van was /is working. They reset the error (no charge). Let's monitor
Today the error is back, the van is very hard to start, it stalls unless you
press on the gas. It has stalled on the wife when driving aswell. .Presently the Service light is back on, it went off earlier today.
It also seens to "miss" while driving.
Any thoughts, it old and this is an intermittent issue which makes it
tougher.
Russ
Captain
Joined: Dec 2006
Posts: 586
Likes: 0
From: Atlanta
RE: 97 Caravan Stalls, Code P0108?
PM me your email and i will get u the PDF of the flow chart so that u can check it yourself.
possable causes
Signal wire open.sensor ground ckt,signal and sensor ground short together,pcm,sensor terminals,pcm other connectors.
possable causes
Signal wire open.sensor ground ckt,signal and sensor ground short together,pcm,sensor terminals,pcm other connectors.
