Hi Andrew, Regretfully my attachment is too large for this forum. If you have an email address more than happy to get the information to you via that medium. Regards... David

 

Hi David my email is butch631@hotmail.com also there are some numbers on the left hand side behind the starter motor i think they are some thing like this 29807030and they are not punched in to the block but embossed on the casting just like the made in brazil is on the rh side

 

I have an AT4 truck with the paint code described as Balm 13211

 

Hey,

So I know nothing about cars, so bare with me please! I also don't know if I should be posting this here.

My husband is restoring an AT4 and since he is useless with the internet, I have been searching for parts for him.

He asked me to locate a wiper skittle panel for his truck. After some internet research I believe what he wants is a wiper skuttle panel. I am unable to find one anywhere.

Two questions:
1. does anyone have any idea of a good place to get one?
2. Is it possible to use one from a different vehicle, that will work?

Any help will be appreciated...Thanks!

 

I just purchased at114 panel van 1962 model in not to bad of shape thank mousey for that thread it was a great help I will post photos in the near future thanks andrew

 

Hi Mousey et al , as the owner of an AT4-114 318 (1966) that I've had in storage for over 10 years, I'd like some help sourcing parts etc to restore the bugger to daily driver condition ...all advice appreciated...

 

I have both the Parts and Service manuals covering the AT4 range, these manuals include all engine options. I paid $350 for these and looking to the same in return. (plus postage/delivery from Cairns, QLD) anyone interested?

 

Hi \
Looking to buy a lwb 300 AT4 or D5n, have found one that suits mechanically but the cab is RUSTY. does anyone know a good place to get replacement panels or a whole cab?

Warren

 

Hello All,
I am a new member of the forum and have found it interesting and informative over time.

I own an RV1 valiant and have an AT4 353 tray back (restorable parts truck) but my son in law has just purchased a 1971 plated AT4 129 with a 245 hemi motor. I don't think it is the original motor going by the engine number, but that is a bit confusing. The block cast number is A2899230 and the engine number is D613k 01334. It all makes sense except the 6, it is a hemi motor, low compression, 3 speed manual built in 1979 but I can't find any reference to what the 6 stands for, does it designate the truck engine?

Regards
Peter
Cairns

 

Does anyone know of any after market rims for the Dodge D5n 300?
I would like to get rid of the old split rims and dress the 300 up. It has duals on the rear and the existing rims are 6 stud 16 inch rims.
Any information will be appreciated.