Can the oil change warning be reset with a scan tool?
Or is it dealer only?

 

Spillage,

To reset the oil change indicator system (after performing the scheduled maintenance) for,

Vehicles Equipped with Keyless Enter-N-Go:
1. Without pressing the brake pedal, press the ENGINE START/STOP button and cycle the ignition to the ON/RUN position (Do not start the engine)
2. Fully depress the accelerator pedal, slowly, 3 times within 10 seconds.
3. Without pressing the brake pedal, press the ENGINE START/STOP button once to return the ignition to the OFF/LOCK position.

Vehicles Not Equipped with Keyless Enter-N-Go:
1. Turn the ignition switch to the ON/RUN position (Do not start the engine).
2. Fully depress the accelerator pedal, slowly, 3 times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.

Please note; if the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.

This information can be found starting on page 303 of the Owner's Manual. If you have any questions please feel free to PM me.

 

Thank you Katie... your time in responding is appreciated.

 

Spillage,

No problem, I hope this helps.