2009 dodge journey drivers door control
Drivers door control does not work for mirrors, door locks and front driver and passenger windows.It does operate the rear passenger windows.Need a schematic or assistance in troubleshooting.Replaced control but still same
Otherwise, you'll need to get into the rubber loom in the door jamb and see which wire is broken. You sould probably go ahead and replace the harness because another wire will probably break down the road sometime.
Last edited by TNtech; Nov 11, 2012 at 10:03 PM.
I got a feeling your driver's door module is bad. I've replaced a few of them b4 for this problem. It can only be check with a enhanced scanner.
the reason your rear windows works fine because the rears window control doesn't go thru the door modules.
the reason your rear windows works fine because the rears window control doesn't go thru the door modules.
Last edited by steak59; Nov 12, 2012 at 02:30 AM.
Trending Topics
Hey guys,I just finally got back to that drivers door.I load tested the wires from the door jamb to the bigger black plug on the control and didn't find any issues.Does the door module also control the locks and mirrors.If so where do i find the module in the car.
Thanks for the replies
Thanks for the replies
Hey guys,I just finally got back to that drivers door.I load tested the wires from the door jamb to the bigger black plug on the control and didn't find any issues.Does the door module also control the locks and mirrors.If so where do i find the module in the car.
Thanks for the replies
Thanks for the replies
Yes, it controls everything on the driver's door, Mirror, locks, and windows.
There is no way to diagnose it without an Chrysler enhanced scanner, because it is CAN BUS commincation based.
They are plug and play, no programing require as for repair.
i have a 2009 dodge journey with the same problem i have no recall on it checked at 2 differnt dealers i can not get my windows to work i pulled my door off and dont see a black box cant find it i have the 2.4 lt se


